This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rudder Sense Resistor Network
Looking for clarification re: connection of pot for rudder sense....

Is the pot (and any associated additional connected resistors) in addition to R7,R8 & R9 (J3) or 'in place of' for the connection to A4?

Many thanks.
It depends on the motor controller.

The adc voltage range is either 0-1.1 volts or 0-5 volts, so depending on this, there are sometimes additional resistors.

Forum Jump:

Users browsing this thread: 1 Guest(s)