2023-05-18, 12:50 PM
I installed a complete OpenPlotter update on a Rasberry Pi 3+ and now the system is a mess. OpenCPN almost doesn't work at all. If I go into OpenCPN in regular mode the entire system locks up and requires a hard shutdown. In safe mode it hangs only OpenCPN.
The is a process that is called "Node" (PID 430, State R, PPID 423) that is using 30 to 50% of the resources without me opening any programs. Could that have anything to do with it?
So far, I have not performed any setup procedures in OpenPlotter, so I don't think I have messed anything up. The only thing I have done is put the maps in a directory and point OpenCPN to them.
I would appreciate any help.
The is a process that is called "Node" (PID 430, State R, PPID 423) that is using 30 to 50% of the resources without me opening any programs. Could that have anything to do with it?
So far, I have not performed any setup procedures in OpenPlotter, so I don't think I have messed anything up. The only thing I have done is put the maps in a directory and point OpenCPN to them.
I would appreciate any help.