General discussion
Important Threads
- Power module for MacArthur HAT in Raspberry 5 (37 Replies)
- MacArthur HAT production (125 Replies)
- MacArthur HAT Documentation (1 Reply)
Threads
- Which device maps to NMEA 1? (2 Replies)
- BMP388 on I2C Bus (0 Replies)
- Smoke when turning the power on (3 Replies)
- I powered the pi with USB and sent 12v to the 12v switch port. Whoops. (3 Replies)
- More than 2 NMEA talkers on MacArthur HAT (5 Replies)
- HY-WDC2E wind with MacArthur hat (2 Replies)
- Maiana connection problem (30 Replies)
- Maina intermittent issue (59 Replies)
- Openplotter/MacArthur Hat and Volvo Penta Multilink Interface (1 Reply)
- Maiana connection problem (0 Replies)
- Mistakenly powering the HAT when not on the Pi (4 Replies)
- SeaTalk 1 RaspPi Wifi Interferance (1 Reply)
- Power Down not working as it should (8 Replies)
- Yellow traffic light goes out before boot is completely (5 Replies)
- Install without openplotter (5 Replies)
- Remove E80 plotter and connect Seatalk1 instruments to MacArthur HAT? (8 Replies)
- Power for Pi4 + McArthur Hat + Power Module (2 Replies)
- Maiana AIS show only boats near me (1 Reply)
- Maiana Blue + MacArthur HAT behavior (2 Replies)
- Is it posible to have Seatalk1 output? (18 Replies)