How do I...?
Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63
Threads
- Sevcon Gen4 controller connection to OpenPlotter (5 Replies)
- Openplotter 3 64 bit - No Seatalk1, GPIO app unavailable. (15 Replies)
- About smoothing signals. (6 Replies)
- Autopilot Navman + Openplotter (1 Reply)
- update opencpn 5.8.0 (5 Replies)
- CAN connection not showing in SignalK (Extended CAN Frame support issue?) (4 Replies)
- Enable/disable Software TX Switch in MAIANA from SignalK? (14 Replies)
- IMU placement (6 Replies)
- Maiana connection problems (12 Replies)
- Convert this .NET SPA site into SignalK plugin (5 Replies)
- Built new NMEA sentence with Barometric pressure inhg and millibars (2 Replies)
- no HDMI audio from OpenPlotter, but VLC works RPI 4B (2 Replies)
- Signal K Paths to InfluxDB (3 Replies)
- RS485 CAN HAT [RESOLVED] (9 Replies)
- BME 280 to Signal K (15 Replies)
- Nasa Marine wind masthead unit (5 Replies)
- MQTT data - how do get this into Signalk/influxdb? (1 Reply)
- Installing NmeaConverter (2 Replies)
- Mapping SOG to Speed Thru Water (6 Replies)
- How to convert radians to degrees in Grafana (5 Replies)